Contact

Dr. Thomas Höhne
Computational Fluid Dynamics
t.hoehneAthzdr.de
Phone: +49 351 260 - 2425
Fax: +49 351 260 - 12425

CFD simulation of fibre material transport in a PWR core under loss of coolant conditions

During a postulated cold leg LOCA with hot leg ECC injection, a limited amount of small fractions of the insulation material after passing the sump strainers can enter the upper plenum and can accumulate at the fuel element spacer grids, preferably at the uppermost grid level. This effect might affect the ECC flow into the core and could result in degradation of core cooling. The CFD simulations show that after starting the sump mode, the ECC water injected through the hot legs flows down into the core at so-called “brake through channels” located at the outer core region where the downward leg of the convection role had established. The hotter, lighter coolant rises in the center of the core. As a consequence, the insulation material is preferably deposited at the uppermost spacer grids positioned in the break through zones (Fig. 1). This means that at the beginning the fibers are not uniformly deposited over the core cross section.

RDB Siebmodell

Fig. 1 Rock wool mass load  [kg/m²] upper spacer grid 30s after start-up of ECC injection

Literature

Höhne, T.; Grahn, A.; Kliem, S.; Rohde, U.; Weiss, F.-P.
Numerical simulation of the insulation material transport in a PWR core under loss of coolant conditions
Nuclear Engineering and Design 258(2013), 241-248

Höhne, T.; Grahn, A.; Kliem, S.; Weiss, F.-P.
CFD simulation of fibre material transport in a PWR under loss of coolant conditions
Kerntechnik 76(2011), 39-45

Höhne, T.
Anwendung von CFD-Methoden für den Kern sowie den Primärkreislauf von LWR
atw - International Journal for Nuclear Power 8/9(2009), 546-548

Links

Contact

Dr. Thomas Höhne


Contact

Dr. Thomas Höhne
Computational Fluid Dynamics
t.hoehneAthzdr.de
Phone: +49 351 260 - 2425
Fax: +49 351 260 - 12425