Thermomechanische Modellierung eines Reaktordruckbehälters in der Spätphase eines Kernschmelzunfalls

Considering the late in-vessel phase of an unlikely core melt down scenario in a light water reactor (LWR) with the formation of a corium pool in the lower head of the re-actor pressure vessel (RPV) the possible failure modes of the RPV and the time to failure have to be investigated to assess the possible loadings on the containment. In this work, an integral model was developed to describe the processes in the lower plenum of the RPV. Two principal model domains have to be distinguished: The temperature field within the melt and RPV is calculated with a thermodynamic model, while a mechanical model is used for the structural analysis of the vessel wall.
In the introducing chapters a description is given of the considered accident scenario and the relevant analytical, experimental, and numerical investigations are discussed which were performed worldwide during the last three decades. Following, the occur-ring physical phenomena are analysed and the scaling differences are evaluated between the FOREVER-experiments and a prototypical scenario.
The thermodynamic and the mechanical model can be coupled recursively to take into account the mutual influence. This approach not only allows to consider the tem-perature dependence of the material parameters and the thermally induced stress in the mechanical model, it also takes into account the response of the temperature field itself upon the changing vessel geometry.
New approaches are applied in this work for the simulation of creep and damage. Using a creep data base, the application of single creep laws could be avoided which is especially advantageous if large temperature, stress, and strain ranges have to be covered. Based on experimental investigations, the creep data base has been de-veloped for an RPV-steel and has been validated against creep tests with different scalings and geometries.
It can be stated, that the coupled model is able to exactly describe and predict the vessel deformation in the scaled integral FOREVER-tests. There are uncertainties concerning the time to failure which are related to inexactly known material parame-ters and boundary conditions.
The main results of this work can be summarised as follows: Due to the thermody-namic behaviour of the large melt pool with internal heat sources, the upper third of the lower RPV head is exposed to the highest thermo-mechanical loads. This region is called hot focus. Contrary to that, the pole part of the lower head has a higher strength and therefore relocates almost vertically downwards under the combined thermal, weight and internal pressure load of the RPV.
On the one hand, it will be possible by external flooding to retain the corium within the RPV even at increased pressures and even in reactors with high power (as e.g. KONVOI). On the other hand, there is no chance for melt retention in the considered scenario if neither internal nor external flooding of the RPV can be achieved.
Two patents have been derived from the gained insights. Both are related to pas-sively working devices for accident mitigation: The first one is a support of the RPV lower head pole part. It reduces the maximum mechanical load in the highly stressed area of the hot focus. In this way, it can prevent failure or at least extend the time to failure of the vessel. The second device implements a passive accident mitigation measure by making use of the downward movement of the lower head. Through this, a valve or a flap can be opened to flood the reactor pit with water from a storage res-ervoir located at a higher position in the reactor building.
With regard to future plant designs it can be stated - differing from former presump-tions - that an In-Vessel-Retention (IVR) of a molten core is possible within the reac-tor pressure vessel even for reactors with higher power.